Tabla De Contenido; Tools Needed For Assembly - PEERLESS SmartMount SCS221 Instalación Y Montaje

Repisa para componentes
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity. See page 1.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1 800 865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
x
Wood Stud
x
Wood Beam
x
Solid Concrete
x
Cinder Block
Metal Stud
Brick
Other or unsure?

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 5/32" bit for wood stud wall
• 1/4" bit for concrete and cinder block wall
• 11/16" bit for drywall
• level
Table of Contents
Parts List .............................................................................................................................................................................. 3
Pre-assemble shelf ............................................................................................................................................................... 4
Installation to Double Wood Stud Wall ............................................................................................................................... 5-6
Installation to Concrete or Cinder Block Wall ........................................................................................................................ 7
Installing Shelf ...................................................................................................................................................................... 8
Installing Surge Protector ..................................................................................................................................................... 8
Installing Covers .................................................................................................................................................................... 8
Visit the Peerless Web Site at www.peerlessmounts.com
WARNING
ADDITIONAL HARDWARE REQUIRED
None
None
None
None
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Contact Customer Service
Contact Customer Service
Accessories
• 2 piece Metal Stud Fastener Kit (ACC 215)
2 of 24
(Metal Stud not evaluated by UL)
For customer care call 1-800-865-2112 or 708-865-8870.

Publicidad

Tabla de contenido
loading

Tabla de contenido