Pre-Assemble Shelf - PEERLESS SmartMount SCS221 Instalación Y Montaje

Pre-assemble Shelf

Insert nine button bumpers (E) into shelf base (A)
1
indicated by arrows as shown below.
Place shelf glass (B) onto shelf base as shown right.
Note: Be certain shelf glass does not cover screw insert
holes on shelf base (A).
A
1-1
Insert three button bumpers (E) into shelf
mounting plate (C). Attach shelf mounting plate
(C) to shelf base (A) using two 1/4-20 x 3/4" flat
head socket screws (D) as shown in figure 1.1.
WARNING
• Tighten screws so shelf mounting plate and glass are
firmly attached, but do not overtighten. Overtightening
can damage glass or screws.
fig. 1.1
E
Visit the Peerless Web Site at www.peerlessmounts.com
E
A
D
C
B
1-2
Thread two 1/4-20 x .75" socket screws (N) into
shelf base (A), leaving 1/4" of exposed thread
between the head of screw and shelf base as
shown in figure 1.2.
Repeat steps 1 through 1-2 for second shelf.
fig 1.2
1/4"
A
4 of 24
A
ISSUED: 08-27-07 SHEET #: 083-9007-2 07-09-08
For customer care call 1-800-865-2112 or 708-865-8870.
SCREW INSERT
HOLES
N
A