Installing Shelf; Installing Surge Protector; Installing Covers; Issued: 08-27-07 Sheet #: 083-9007 - PEERLESS SmartMount SCS221 Instalación Y Montaje

Installing Shelf

4
Be certain there is 1/4" of exposed thread on two
socket screws of the shelf assembly. Hook shelf
assembly into keyhole slots on the bottom of wall
plate (F) as shown. Securely tighten socket
screws.
SOCKET SCREWS

Installing Covers

6 Snap mount covers (G and H) as shown
right. Be certain tabs on the inside of wall
plate cover (G) engage top holes on wall
plate (F).
Insert grommet (I) into top cover (G)
if desired.
Note: A portion of grommet can be cut
away to allow for cable passage.
To remove top cover (G), push the side tabs
outward on cover and pull forward as shown
in figure 6.1.
fig. 6.1
Visit the Peerless Web Site at www.peerlessmounts.com
F
SHELF
ASSEMBLY
PUSH TABS
OUTWARD
Installing Surge Protector (optional)
A surge protector (not included) can be fastened to
5
the tabs on the inside of wall plate (F) using cable
ties (P) as shown.
Note: the maximum dimensions of surge protector
that can be placed into upper wall plate (F) is 11"
long by 2" wide. Outlets of surge protector must face
inward as shown.
F
TABS
CUT (OPTIONAL)
I
G
8 of 24

ISSUED: 08-27-07 SHEET #: 083-9007-2 07-09-08

For customer care call 1-800-865-2112 or 708-865-8870.
All other brand and product names are trademarks or registered trademarks of their respective owners.
SURGE
PROTECTOR
TABS
P
HOLES FOR TOP
COVER TABS
F
H
© 2008, Peerless Industries, Inc. All rights reserved.