PEERLESS SmartMount SCS221 Instalación Y Montaje página 6

Installation to Double Wood Stud Wall (continued)
2-1
Insert two 1/4-20 x 3" screws (L) through wall plate (F). Thread two toggler wings (M) onto 1/4-20 x 3" screws (L)
into the position shown in figure 2.1.
L
2-2
Place wall plate (F) against wall while pushing toggler wings (M) through pre-drilled holes in wall as shown in
figure 2.2. Level wall plate (F) and secure using two #14 x 2.5 wood screws (J). Pull forward on 1/4-20 x 3"
screws (L) until toggler wings (M) are flush against inside of drywall as shown in figure 2.4. While pulling
backward on 1/4-20 x 3" screws, tighten toggler wings by turning clockwise until toggler wings are fully secured
as shown in figure 2.2.1.
Skip to step 4 to install shelf
F
J
M
L
fig. 2.2
Visit the Peerless Web Site at www.peerlessmounts.com
M
F
fig. 2.2.1
F
1
M
Pull back on screws (F) untill toggler wings (M) are flush
against drywall.
2
While pulling back on screws, turn clockwise to tighten.
3
Tighten screws (L).
6 of 24
fig. 2.1
F
L
F
L
L
F
F
L
ISSUED: 08-27-07 SHEET #: 083-9007-2 07-09-08
For customer care call 1-800-865-2112 or 708-865-8870.
M
M
M