Yakima Q TOWERS Guia De Inicio Rapido página 2

ASSEMBLE TOWERS, END CAPS AND PADS ON BARS
SLIDER
MARKS
TOWER HOOD
GOLD SLIDER
Bar*
Cover
SCREW
Tower
Brass
Fastener
Lock
Holder
Pad*
*PURCHASED SEPARATELY
M BETWEEN
EASURE BAR TOWER HOODS
IMPORTANT: Follow "M1" measurement from
list in clip box.
M1
KEEP SCREWS IN
TOWERS LOOSE.
F P & E :
RONT ADS NDCAPS
• Put 1 rubber pad from clip boxes
on base of each Tower.
• Put black
endcaps
on front bar.
ON SOME CARS: CLIPS AND PADS are
DIFFERENT for the front and rear. Be
sure to place them correctly (see clip
instructions).
To Prepare: TO BEGIN:
Black
Loosen screws
• Clean roof of car.
Vinyl
on each tower turning
• Remove towers
Liner*
counter clockwise.
from box.
Clip* • Remove bars
from plastic
holders.
• Open clip boxes
and plastic bag.
—
C
HECK MEASUREMENT
• Lift Tower Hood & Crossbar
TOGETHER so that tower drops.
• Insert wrench in hole.
• Turn wrench a short turn
clockwise—this locks the Tower to
the bar.
Repeat with other Tower.
CHECK MEASUREMENT AGAIN!
Tower may have moved during
tightening.
A R R : Repeat Steps 2
SSEMBLE EAR ACK
through 5.
IMPORTANT: You must use "M3" measurement
from list in clip box.
M3
LABEL rear
Towers with
rear stickers.
I T C
NSTALL OWERS TO ROSSBAR ON FLAT SURFACE
• PULL tower hood UP so
that wrench will engage
when inserted in hole.
Keep
Cover OPEN.
... T :
LOCK OWERS
O C D :
PEN AR OORS
• WITH CAR DOORS OPEN,
gently place front rack on
roof.
• CENTER THE RACK:
Measure side to side. Door
frame to tower base must be
equal on both sides of car.
:
• Turn wrench • Slide bar into
counter clockwise tower, remove
until it stops.
wrench. REPEAT
for other tower.
L :
ABEL
Front Towers
with "
front"
stickers.
M F R —
EASURE RONT ACK
• Measure: top of windshield where paint
ends, to front of Towers.
USE "M2" measurement from list in clip
box.
M2