Safety Check - Yakima Q TOWERS Guia De Inicio Rapido

ATTACH RACK TO CAR
I C :
NSTALL LIPS
• Line front & back of clips with
black vinyl liners;
trim if necessary.
• Slip lined clip
into Tower
through slits
on side.
F T T
INE UNING THE OWER TENSION
• Gold sliders should be an equal distance
from the slider marks on each tower.
• IF the gold sliders are not equal
distances, loosen or tighten screws until
sliders are equal.
TOWER
SAFETY
CHECK
WITH DOORS OPEN, CHECK BOTH TOWERS:
• GRAB BAR on inside of Towers, push & pull
(use arm strength, full body strength not
necessary). Tower should not move.
• IF TOWERS MOVE, tighten screws slightly.
• KEEP SLIDER MARKS EQUAL.
• CLOSE COVER & CHECK AGAIN —
If towers move, check measurements again.
I L H
NSTALL OCK OLDER
& B F :
RASS ASTENER
• Insert lock holder into holes in
Clip & Tower, matching notches.
• Push brass fastener over lock
holder. It should feel snug.
• Repeat steps 9 & 10 for other
Tower.
:
NOTE:
The gold sliders may
The gold slider
fall below or cover up
should NEVER
slider marks
TOUCH the
depending on the
crossbar.
make of car.
A R R : R
TTACH EAR ACK EPEAT
• Use "M4" measurement from list in clip box.
• MEASURE FROM CENTER OF EACH BAR.
• REPEAT SAFETY CHECK in steps 13 & 14 .
M4

SAFETY CHECK

PULL Clips, GRAB Bars
S C '
ECURE THE RACK TO AR
• Tighten one side slightly so that cam
cover closes with light pressure—and
without moving the tower. Do not
overtighten. Close cover.
• Go to opposite side, tighten screw
slightly, close cover.
• Tighten each side as evenly as
possible—a few turns on one tower,
then a few on the other. Open and
close cam covers with each
adjustment.
• Tighten until the covers close
firmly—with some resistance.
This needs to be done gradually
to prevent the towers from
moving off center.
CLIP
SAFETY
CHECK
S 9 14
CONGRATULATIONS! Now you can enjoy
TEPS THROUGH
your favorite adventures made convenient
by your durable Yakima Rack!
TO REMOVE RACK:
• Open tower covers & lift rack
up and off (do NOT
disassemble).
TO RE-INSTALL:
• Place Towers (covers open)
in original positions.
• Close Tower covers &
recheck rack and clips (Steps
13 & 14). Tighten if needed.
:
S ROOF
WITH DOORS OPEN:
• PULL each clip away from car—PULL HARD!
• DO THIS FOR EACH CLIP.
• If clip moves, open cover and tighten
screw. Close cover and check clip
again.
• If it still moves, check M1 mea-
surement in Step 3 and re-tighten.
– KEEP SLIDER MARKS EQUAL –
Other Information:
®
• SKS Lock Cores: Follow
directions and install with
Tower covers closed.
• To secure long loads:
Use tie-downs at front
and rear of vehicle.
Check clip
instructions in
clip box for
special NOTES
that may apply
to your car.