Assembly Procedure - Panasonic TY-ST20-K Istrucciones De Instalación

Components
Stand base (1)
Stand pole installation screw (4)
M5X14
Overturn-prevention parts
① Overturn-prevention belt (2)

Assembly Procedure

1. Assemble the Pedestal
Make sure you do not scratch the surface of the
stand base.
Align stand base
the left and right sides, and use the stand pole
installation screws
attach the stand poles as shown in the
diagram.
(Tightening torque: 1.5 to 1.8 N•m)
10
Check that all the parts are accounted for and present in their designated quantities.
Unit installation screw (4)
M5X30
② Screw (2)
with the stand poles on
(4 screws) to
Stand pole (One for each side, L(left) and R(right))
L
[ The images shown in this manual are for illustrative purpose only.]
Stand pole L
Stand base
R
Clamper (1)
③ Wood screw (2)
Stand pole installation
screw
Stand pole R