Publicidad
Enlaces rápidos
Publicidad
Manuales relacionados para Kuat GRIP 4
Resumen de contenidos para Kuat GRIP 4
- Página 1 GRIP ™ USER GUIDE...
- Página 2 Cool Keychain M5 Allen (4) M6x25mm Bolt (4) Flip Mounts M4 Allen (2) M6x18mm Washer 165 lbs Maximum Weight GRIP 4: 17 lb CROSSBARS SKIS / SNOWBOARDS GRIP 6: 23 lb 4.25” Max Crossbar Width 2” .5” Min Crossbar Height...
- Página 3 Unlock & Open the GRIP Slide Locking Tab left to release the GRIP Rack handle. Locked Unlocked Pull GRIP handle upward to unlatch and open.
- Página 4 Mounting Universal FLIP Mounts With GRIP open, align (1) FLIP Mount and (1) M6 Bolt with front bolt hole. Note: M6x18 Washer is pre-assembled in this location. Thread M6 Bolt into FLIP Mount and tighten with the included M5 Allen Wrench. The GRIP 6 features two forward mounting locations.
- Página 5 Pull against the Tray Tab to unlock, then slide GRIP Tray outward, exposing rear mount bolt hole. Align second FLIP Mount, (1) M6 Bolt, and (1) M6x18 Washer with rear bolt hole. Thread M6 Bolt into FLIP Mount and tighten with M5 Allen Wrench. Repeat these steps for the second GRIP rack.
- Página 6 Using the Universal FLIP Mounts Pivot lever upward to release strap. With both FLIP Mounts open, place GRIP onto crossbar in the desired location, looping FLIP straps under and back into the strap lever. Close FLIP Mount lever and repeat for opposite side.
- Página 7 Snug mounts to crossbar by retightening the Strap Tensioner using the provided M4 Allen Wrench. When tightening FLIP straps, check the lever periodically. Lever should be snug, but not too difficult to articulate. Once straps have been properly adjusted to the crossbar, further adjustment should not be necessary to remove or reinstall the GRIP racks.
- Página 8 GRIP Leveling Depending on your crossbars and vehicle, it may be necessary to adjust the angle of your GRIP racks so that they sit level relative to the vehicle roof. Adjust the angle of your mounts and GRIP rack using the Angle Adjustment bolt and the provided M4 Allen Wrench.
- Página 9 Pull against Tray Tabs to unlock and slide GRIP Trays outward. (See Step 5) Load thickest skis first, with ski tips toward rear of vehicle. Keep at least .5” of clear space between skis and tray edge to prevent potential for damage when closing GRIP racks. .5”...
- Página 10 Close and secure each GRIP rack. Confirm tab is in the Locked position. Secure Locking Tab with provided key. Always secure and lock each GRIP rack when traveling or storing.
- Página 11 • Do not take through automatic car wash. • Drive responsibly. If you have questions or problems, please contact Küat Racks directly by calling toll free 1(877)822-KUAT, or by email: info@kuatracks.com ADVERTENCIAS • Siga las instrucciones o el montaje correcto, las instalaciones y el uso.
- Página 12 Küat Racks Limited Lifetime Warranty Küat honors the warranty on all Küat brand products for original owners of the product. Warranty is not transferable. If a Küat rack that is covered by the terms of this warranty and is determined by Küat to be defective, Küat will repair or replace the defective parts.
- Página 13 1.877.822.5828 info@kuatracks.com kuatracks.com kuatracks.com...