Chicco Rodeo Manual Del Usuario página 11

• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct
function of this product.
• Never mix new and old or different types of batteries.
• Always keep batteries and tools out of reach of children.
• Do not short-circuit the battery terminals.
• Always remove spent batteries from the toy to avoid the danger of leakage from the battery damag-
ing the product.
• Always remove the batteries if the toy will not be used for a long period of time.
• Remove the batteries from the toy before disposal.
• Do not burn or dispose of spent batteries into the environment. Dispose of them at an appropriate
differentiated collection point.
• In the case of battery leakage, replace them immediately and clean the battery compartment care-
fully. Wash hands thoroughly if they come into contact with the leaked fluid.
• Do not attempt to recharge non-rechargeable batteries, they might explode.
• The use of rechargeable batteries is not recommended, since they might impair the toy's functionality.
• If rechargeable batteries are used, remove them from the toy before recharging; this operation must
be carried out only under adult supervision.
This Product Is Approved To Eu 2002/96/ec Regulation.
The crossed bin symbol shown on the equipment indicates that, at the end of its useful life-cycle,
the product must be treated separately from domestic waste, and disposed of at an appropriate
differentiated collection point for electrical or electronic equipment, or delivered to the retailer at
the time of purchase of new, equivalent equipment. The user is responsible for disposing of, or delivering,
the worn or damaged equipment to the appropriate collection points. The appropriate differentiated
collection and subsequent recycling or treatment of the equipment disposed of, in compliance with
environmental norms, helps to avoid possible negative effects on health and on the environment, and
favours the recycling of the materials that the product is made of. For further information on the col-
lection systems available, please contact your local waste disposal service, or your retailer.
HOW TO ASSEMBLE THE TOY
Diag. 1
• Assemble the head, placing it on top of the body and tightening the 4 screws supplied. Ensure the
screws are tightened firmly and safely into position.
Diag. 2
• Place the "foulard", as shown in the diagram, and lock it in position with the clip.
Diagrams 3,4,5, 5a
• Join the front part to the rear part of each rocking base. Insert the Chicco brand into the central hous-
ing, then turn the assembled rocking bases over to tighten the 2 screws into their housings, as shown
in the diagram. Ensure the screws are tightened firmly and safely into position.
• Join the two rocking bases with the front and rear locking devices (diag. 5a). Each locking device must
be fitted correctly into the rocking bases. Always check that the frame is assembled and fitted cor-
rectly into the four locking points.
HOW TO USE THE TOY
Diag. 6
• The system connected to the handle allows you to adjust the strength with which the horse moves
11