Publicidad
Idiomas disponibles
Idiomas disponibles
23. Trim all excess wire tie length - see Figure 24.
Passenger's Seat Wire Harness Assembly:
24. Disconnect passenger's seat wiring harness (smaller of
the two seat harnesses) from body harness jumper - see
Figure 25.
FIGURE 25
25. Passenger's wire harness assemble process is similiar
to driver's seat except there is no heated seat module in
the passenger's seat (driver's seat module controls both
front seats) and most likely fewer or no seat motors.
Make sure to wire tie excess to existing seat wiring
(trim excess wire tie length) - see Figure 25.5.
FIGURE 25.5
Final Seat Assemble Step Prior to Reinstallation in Vehicle:
26. Reinstall seat back cushion finish panel to both front
seats.
Heated Seats
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
FIGURE 24
REVISION
Accessory Body Wire Harness Installation - Floor Pan
Routing:
27. Remove driver's side door sill plate - refer to Service
Procedure 1674191.
28. Route body harness jumper underneath carpet, route
seat in-line connectors though existing wiring hole in
carpet, and wire tie to existing floor wiring harness (trim
excess wire tie length) - see Figures 26 and 27.
FIGURE 26
29. Route body harness jumper underneath rear HVAC duct
and console (on top of carpeting) to passenger's side of
vehicle - see Figures 28 and 29.
FIGURE 28
30. Route body harness jumper underneath carpet and rear
HVAC duct, route seat in-line connector though existing
wiring hole in carpet, and wire tie to existing floor wiring
harness (trim excess wire tie length) - see Figure 30.
PART NO.
REV 13MR08
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
PART NO.
19159289
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FIGURE 27
FIGURE 29
FIGURE 30
19159289
SHEET
Heated Seats
4
SHEET
4
24
OF
24
OF
Publicidad
