Samsung BRF425200A Manual Del Usuario página 23

06 Filter Reset (3 sec)
Filter Reset
07 Deodorizer Reset (3 sec)
Deodorizer Reset
08 Door Alarm / °C  °F (3 sec)
Door Alarm
°C  °F
Untitled-6 23
After about 6 months of using the original water filter (which
typically amounts to about 300 gallons or 1136 liters of water),
the filter indicator blinks red to remind you that the filter needs
to be replaced.
When this happens, replace the filter, and then press and hold
Filter Reset for 3 seconds. This resets the filter lifecycle detector
and turns off the filter indicator.
NOTE
• Some areas have relatively large amounts of lime in their
water. This may reduce the lifecycle of the filter. In these
areas, you will have to replace the water filter more often than
specified above.
• If water is not dispensing properly, the water filter is most
likely clogged. Even if the filter indicator is not blinking,
replace the water filter.
After about 18 months of using the original deodorizer filter, the
filter indicator blinks red to remind you that the filter needs to
be replaced. When this happens, replace the filter, and then press
and hold Deodorizer Reset for 3 seconds. The filter lifecycle will
be reset and the filter indicator turns off.
You can enable or disable the door alarm by pressing Door Alarm.
When Door Alarm is enabled and a door is left open for more than
2 minutes, the alarm will sound and the alarm indicator will blink.
The Door Alarm function is enabled by factory default.
You can use the Door Alarm button to switch the temperature
scale between Celsius and Fahrenheit.
To switch the temperature scale, press and hold Door Alarm for
3 seconds.
English 23
2018-07-05 7:25:41