Self-Cleaning Cycle; Range Care - Kenmore 665.9214 Manual De Uso Y Cuidado

RANGE CARE
Burn Hazard
Do not touch the oven during the
Self-Cleaning cycle.
Keep children away from oven during
Self-Cleaning cycle.
Failure to follow these instructions can result
in burns.
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off during the Self-Cleaning cycle. Exposure to
the fumes may result in death to certain birds. Always move birds
to another closed and well ventilated room.
Self-clean the oven before it becomes heavily soiled• Heavy soil
results in longer cleaning and more smoke.
Keep the kitchen well-ventilated during the Self-Cleaning cycle to
help get rid of heat, odors, and smoke.
Do not block the oven vent(s) during the Self-Cleaning cycle. Air
must be able to move freely• Depending on your model, see
"Oven Vent" or "Oven Vents" section.
Do not clean, rub, damage or move the oven door gasket. The
door gasket is essential for a good seal.
Prepare Oven:
• Remove the broiler pan, grid, cookware and bakeware and,
on some models, the temperature probe from the oven.
• Remove any foil from the oven because it may burn or melt,
damaging the oven.
• Remove oven racks to keep them shiny and easy to slide.
See "General Cleaning" section for more information.
Hand clean inside door edge and the 11/2in. (3.8 cm) area
around the inside oven cavity frame, being careful not to
move or bend the gasket. This area does not get hot enough
during self-cleaning to remove soil. Do not let water, cleaner,
etc. enter slots on door frame. Use a damp cloth to clean this
area.
Wipe out any loose soil to reduce smoke and avoid damage.
At high temperatures, foods react with porcelain. Staining,
etching, pitting or faint white spots can result. This will not
affect cooking performance.
Prepare Cooktop and Storage Drawer:
• Remove plastic items from the cooktop because they may
melt.
• Remove all items from the storage drawer.
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring, loss of gloss, hairline cracks and
popping sounds.
SELECT CLEAW M Self-Cleaning Cycle
How the Cycle Works
The SELECT CLEAN Self-Cleaning cycle uses very high
temperatures and dissolves soil to a powdery ash.
SELECT CLEAN will set the clean time automatically, once the
soil level is set.
The soil level can be manually set to light, average or heavy soil
levels by repeatedly pressing SELECT CLEAN.
The oven will automatically shut off once it is clean. The door will
not unlock until the oven cools.
Once the oven has completely cooled, remove ash with a damp
cloth. Do not wipe down any of the inside surfaces until the oven
has completely cooled down. Applying a cool, damp cloth to the
inner door glass before it has cooled completely could result in
the glass breaking.
The oven light will not work during the Self-Cleaning cycle.
To Set SELECT CLEAN:
• Press once for light soils, and "SoilL" will appear on the
display•
• Press two times for average soils, and "SoilA" will appear on
the display.
• Press three times for heavy soils, and "SoilH" will appear on
the display.
To Set CLEAN:
• Press CLEAN. This will automatically set a 3 hour 30 minute
Self-Cleaning cycle.
• Press the HOUR/MIN "up" or "down" arrow pads to set a
Self-Cleaning cycle longer or shorter than the 3 hour
30 minute cycle.
To Start Self-Clean:
Before self-cleaning, make sure the door is closed completely or
it will not lock and the cycle will not begin.
1. Set SELECT CLEAN (on some models) or CLEAN.
2. Press START.
The oven door will lock in 6 seconds and "LOCKED," the start
time and stop time will appear on the display. The door will
not unlock until the oven cools. The cycle time includes a
30 minute cool down time.
When the cycle is complete and the oven cools, "End" will
appear on the display, and "LOCKED" will disappear.
3. Press STOP/CLEAR or open the door to remove "End" from
the display.
4. Close door.
The time of day will appear on the display.
21