Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
MOVE TABLE HALF!
16. Attach other end of linkages #4 to OUTSIDE of U-support #7 with
bolts #14 and plastic washers #24. Then slide name panel #5
onto the same bolts #14 on the INSIDE of U-support #7. Secure
with lock nuts #15 See Figure 5C. Tighten hardware until snug but
do not overtighten. Tubes must pivot freely.
17. Attach bottom of name panel #5 to U-supports #7. Secure with
hex bolts #9 and locknuts #15. Tighten nuts but be careful not
to crush tubes. See Figure 5C.
18. Prepare an area for the assembly of the second
table top half. If necessary, move the first table top
half aside with the aid of a helper. Be sure to place it
in a location where it won't be disturbed or
damaged. If setting on its side, be sure to place the
bottom edge no less than 12 inches away form the
wall. Also be sure to place carpet or pieces of the
shipping carton down to protect table top edges. If
floor is not carpeted, brace table top half with a
heavy object to keep it from sliding.
14
Logo on
#5 panel
9
faces out
9
24
14
15
4
First Table Top
Figure 5C
10
HARDWARE NEEDED
1/4-20 x 2" Hex Head Bolt
(Qty. 2)
1/4-20 x 1 1/2 Bolt
(Qty. 2)
5
7
Plastic Washer
24
(Qty. 2)
¼" Locknut
15
(Qty. 4)
Logo on
#5 panel
faces out
5
9
24
14
15
4
Publicidad
Tabla de contenido
