Escalade Sports prince SPORT T8830 Instrucciones De Ensamblaje página 6

NOTICE
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
5. Lay out Side Rails #25 and End Rail #26, around edges
of table top as shown in Figure 3.
6. Slide Left #33 and Right #32 Vinyl End Caps onto the
ends of the Side Rails #25 as shown in Detail C.
7. Line up holes in rails with indentations in top
and secure using eighteen screws #20. See
Figure 3 & Detail C.
8. Lay Corner Caps #22 on table as shown in
Figure 3. If Corner Cap sticks above the
table top surface of the table, flip over so
the shorter distance is against edge. Secure
to bottom of table with three Screws #21.
See Detail D.
20
33 (LH)
Detail C
20
25
Note: This is the end of the
table with no rails.
6
HARDWARE NEEDED
20 20
#8 X 7/16" Screw
Detail D
Note: Rails attach
with shorter #20
screws
20
Figure
3
7
HARDWARE NEEDED
21
#8 X 5/8" Screw
(Qty. 6)
(Qty. 18)
Longer
Shorter
26
Note: Corner Caps
attach with longer
#21 screws
20
Note: Rails attach
with #20 screws
25
32
(RH)
21