Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
NOTICE
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-CLIPS
(#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED INCORRECTLY,
YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE WHEN YOU ATTEMPT
TO OPEN IT TO THE PLAYING POSITION.
HARDWARE NEEDED
20
#8 X 7/16" Screw
(Qty. 24)
4. Align the holes in the U-clips #3 with the
indentations in table top assembly and secure
with four screws #20 per U-clip as shown. All
four holes in each U-Clip must align with four
Indentations in top. See Figure 2, Detail A and
Detail B.
Detail A
3
IMPORTANT:
Be sure that slot in the three U-clips #3 all
face the same direction as shown. (Toward
the end of the table with no stripe.)
20
7
(U-Support)
3
(U-Leg)
2
Slot in
U-Clip
5
IMPORTANT:
Be sure that slot in the three U-clips
#3 all face the same direction as
shown. (Toward the end of the
table with no stripe.)
20
3
Slot in
U-Clip
Detail B
Figure
2
Publicidad
Tabla de contenido
