Filter Instructions - Oster BVSTKE671 Manual De Instrucciones

FILTER INSTRUCTIONS

A mesh filter has been integrated into the kettle to reduce the amount of scale residues
entering your beverages or food. The filter is removable for cleaning. To reduce scale build-
up, empty out any residual water after boiling.
How often the filter should be cleaned will vary according to where you live and how often you
use your kettle. Filter should be cleaned whenever there are noticeable deposits left on the
filter and especially if the rate of pouring decreases.
Filter Removal/Cleaning/Refitting
IMPORTANT: The kettle must be switched off, disconnected from the power outlet and
allowed to cool down completely prior to removing or refitting the filter. Do not use
excessive force, as this might damage the filter or the lid.
1. Empty the kettle and open lid.
2. Grip the top part of the filter with index finger and thumb. Gently push down and remove
filter. You may have to hold kettle while removing filter.
CAUTION: Keep fingers clear of mesh. Pressing into mesh may damage filter.
3. To clean the filter, rinse under a tap while brushing it gently with a soft brush.
4. To refit filter, once again hold filter with index finger and thumb. Making sure the bottom
tab of the filter is resting on the bottom of the opening, gently push the filter back towards the
spout until you hear a click. The filter is now reattached. Gently tug on filter to ensure filter is
attached properly.
5. Rinse out kettle with fresh water and it's ready for use.
E n g l i s h 6 E n g li s h