M.J. MALLIS GROUP siat F1 Manual De Instrucciones Y Recambios página 70

11-SET UP AND ADJUSTMENT
Thread the film as shown on the label located on top of the film carriage.
Lock the lever of the brake in the working position.
Note: Most strechable films have an adhesive side. Make sure that this
side is positioned as in the drawing. If the film reel is wound with the adhe-
sive side inwards, reverse it and use the threading route shown by the bro-
ken line in the drawing.
FILM REEL CARRIAGE WITH MOTORIZED PRE STRETCH
Position a reel of film on the reel holder.
Maximum reel diameter: 300 mm
Maximum film height: 500 mm
Open the carriage guard and thread the film as shown on the label lo-
cated on top of the film carriage.
Note: Most strechable films have an adhesive side. Make sure that this
side is positioned as in the drawing. If the film reel is wound with the
adhesive side inwards, reverse it and use the threading route shown by
the broken line in the drawing.
Close the carriage guard; as the machine will not operate if this is open.
26/44
Via Puecher, 22 - 22078 TURATE (CO) ITALY - Tel. 02964951 - Fax 029689727 - http://www.siat.com - Email: siat@siat.com
SBC0010338
SIAT S.p.A.
ADHESIVE
ADHESIVE