Bernzomatic ST2200 Manual De Instrucciones página 2

• Extremely hot air escapes from exhaust ports on soldering tip assembly. Always rest torch on the stand supplied, even
during short breaks, to avoid risk of damaging work surfaces or other flammable items. Extinguish torch during longer
breaks. Never point exhaust ports toward eyes, face, hands, or other flammable items.
• Use caution when operating the torch outdoors on sunny or windy days. Bright sun makes it impossible to see the
torch's flame. Wind may carry the torch's heat back towards you or other areas not intended to be heated. Windy
conditions may also cause sparks to be blown into other areas with combustible materials.
• Burner nozzle and tip assembly become extremely hot during use and remain hot after extinguishing the torch. Take
precautions not to touch torch tip until torch has cooled.
• Never use the torch on or near combustibles (fuels, rags, towels, paper products, etc.). Be careful around motor
vehicles or any gasoline-fired products and beware of hidden fuel lines and tanks.
• Always make certain the torch is resting on level surface to reduce the risk of accidental tip over. Be sure the torch is
not pointed in a direction which could cause nearby objects to ignite when the torch is set down.
• Never leave the torch unattended when lit.
• Never attempt to repair or heat a gasoline tank, a chemical drum an aerosol can, a compressed gas container that held
flammable liquid or gas or any other chemical. Heating these is extremely dangerous, especially after they have been "emptied".
• Department of Transportation Hazardous Materials Regulations forbids the carriage of butane or other flammable gas
products on passenger aircraft. Do not pack this item or any other flammable gas item in any checked or carry-on baggage.
• Make sure torch is completely extinguished after use.
• Ensure that torch is completely cool before storing.
EXTREMELY FLAMMABLE. CONTENTS UNDER PRESSURE.
• Take precautions not to heat fuel tank.
• Contains flammable gas under pressure. Do not expose the torch or fuel to temperatures exceeding 120°F/49°C or
prolonged sunlight.
• Never use torch in or around flammable fumes, liquids, or explosive materials.
• Never pierce fuel tank or expose torch to fire.
• Do not breathe gas, fumes, vapor or spray. If inhaled, remove affected person to fresh air.
• Avoid contact with eyes or skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical
advice. For skin contact, flush with large amounts of water.
• Do not modify torch in any way. Do not alter factory settings. Serious injury or death can result from adjusting factory
settings or modifying factory fitted parts. Always use manufacturer recommended replacement parts.
• Read and understand refueling instruction before refueling torch. Refueling the torch incorrectly can result in serious
injury or death.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16