Bernzomatic ST2200 Manual De Instrucciones página 4

CONTINUOUS USE MODE
1. Turn FLAME ADJUSTMENT KNOB (5) approximately halfway between – and + position.
2. Slide the SAFETY LOCK (2) down until it clicks and locks in the ignition position.
3. Press and hold down the IGNITION BUTTON (3).
4. Repeat step 2 and step 3 if torch does not ignite.
5. Press the CONTINUOUS FLAME LOCK (4) in to lock the IGNITION BUTTON (3) in the on position.
6. Release IGNITION BUTTON (3).
7. To extinguish flame, press the IGNITION BUTTON (3) until the CONTINUOUS FLAME LOCK (4) resets and releases.
ADJUST FLAME
1. Slide FLAME ADJUSTMENT KNOB (5) to – for small flame.
2. Slide FLAME ADJUSTMENT KNOB (5) to + for large flame.
USE AS A GAS TORCH
(This is an open flame. Do not use with combustibles in the area. Read warning sections of instruction)
1. Torch is factory set for use as a gas torch and can be used immediately; after refilling.
2. Ignite torch as shown above.
USE AS SOLDERING IRON
Note: A small amount of smoke and/or odor may be noticeable during the initial use of the soldering tip, this is normal.
1. Ensure that the GAS TORCH TIP (6) is cool before installing the SOLDERING TIP ASSEMBLY (7)
2. Loosen soldering tip locking screw by turning it counterclockwise.
3. Install SOLDERING TIP ASSEMBLY (7) onto the GAS TORCH TIP (6).
4. Lightly tighten the soldering tip locking screw by turning it clockwise.
5. Ignite torch as shown above.
6. Allow torch to burn for about 10 seconds until the heating element begins to glow red.
7. Slide the AIR ADJUSTMENT BUTTON (8) forward. This should extinguish the flame and leave only the heating
element glowing red.
8. Torch is now ready for use as a soldering iron.
Note: For best performance, make sure that the tip is tightly installed onto the SOLDERING TIP ASSEMBLY (7).
Do not use tools to tighten tip.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16