Bernzomatic ST2200 Manual De Instrucciones página 3

REFILLING OPERATION
1. Use only Bernzomatic Butane fuel when refilling torch.
2. Ensure that the torch is extinguished before refilling.
3. Allow sufficient time for torch to cool to room temperature before refilling the torch with fuel.
4. Refill torch in a well ventilated area free of fire or other sources of ignition and away from people.
5. Never smoke while refilling the torch.
6. Hold the torch with the FILL VALVE (1) up.
7. Invert fuel canister and insert the fuel canister tip into the FILL VALVE (1).
8. Push the fuel canister and torch together to allow fuel to flow into the torch fuel tank. Torch should be
filled in about 10 seconds.
9. Stop refilling once the fuel begins to overflow.
10. Wait 3 minutes to allow fuel gas to stabilize before igniting the torch.
LIGHTING AND OPERATION
Exercise caution when using this device not to breathe vapors. Depending on the task being conducted with device
(wood burning, melting plastic, etc.) toxic or nauseating vapors may exist.
INTERMITTENT USE MODE
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
1. Turn FLAME ADJUSTMENT KNOB (5) approximately halfway
between – and + position.
2
2. Slide the SAFETY LOCK (2) down until it clicks and locks in
the ignition position.
1
3. Press and hold down the IGNITION BUTTON (3).
4. Repeat step 2 and step 3 if torch does not ignite.
5. Release IGNITION BUTTON (3) to extinguish torch.
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
ST200
08/19/16