Additional Warnings - Bernzomatic ST2200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USE AS A HOT AIR BLOWER
1. Assemble for use as soldering iron (see above).
2. Remove the tip from the SOLDERING TIP ASSEMBLY (7) by rotating it counterclockwise.
Note: Tip may be difficult to remove if the solder tip has never been used. Allow torch to heat up in the soldering iron
configuration (see above) for 3 minutes, then allow the tip to cool.
3. Torch is now ready for hot air blower operation.
4. Ignite torch as shown above.

ADDITIONAL WARNINGS

• Before using as soldering iron or hot air blower ensure that soldering tip locking screwis securely tightened.
• Before each use and after refilling, listen for leaking. Never use a flame to check for leaks. Always use torch in a
well-ventilated and spark-free area and where there are no open flames.
• In cold weather size of flame will be smaller. To produce larger flame, pre-warm torch to room temperature prior to use.
STORAGE
1. Ensure that IGNITION SWITCH (3) is in the "OFF" position.
2. Allow several minutes for torch to cool. Never leave torch unattended.
3. When torch is cool, store torch out of reach of children.
4. Do not expose torch to temperatures in excess of 120°F/49°C
5. Store torch in well ventilated areas.
THREE-YEAR LIMITED WARRANTY
Bernzomatic warrants to the original purchaser that this product is free from defects in material and workmanship for three years
from the date of purchase. This warranty is valid for all purchases of this product on or after June 1, 2016. This warranty does not
apply to product that has been damaged as a result of improper maintenance, accident or other misuse, or which fails to operate due
to normal wear and tear. This warranty is void if the product is repaired or modified in any way by anyone other than Bernzomatic.
Bernzomatic will repair the product if it proves to be defective in materials or workmanship. At the choice of Bernzomatic, a
replacement product may be provided instead of repairing a defective product. The sole obligation of Bernzomatic and your
exclusive remedy under this warranty are limited to such repair or replacement.
To make a claim under this Limited Three Year Warranty, contact any Bernzomatic retailer or contact Bernzomatic directly at
1-800-359-9678. A service representative will assist you. Please provide proof of date of purchase when making a claim.
Bernzomatic makes no other warranties concerning the product, and limits any implied warranties to the length of this Limited
Three Year Warranty. In no event shall Bernzomatic be liable for incidental or consequential damages. Some states do not allow
limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16

Publicidad

Tabla de contenido
loading

Tabla de contenido