Getting Started; Important Installation Instructions - 3M Aqua-Pure AP717 Instrucciones De Instalación Y Funcionamiento

Sistema de filtración en línea
Ocultar thumbs Ver también para Aqua-Pure AP717:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

®
Aqua-Pure
Ice Maker Filters come complete with all the necessary hardware. All you need is a tube cutter,
a wrench and a knife. Simply follow the easy step-by-step instructions to connect the Aqua-Pure Ice Maker
Water Filter to your refrigerator's incoming cold water line.
You can also count on your Aqua-Pure fi lter to virtually eliminate the problem of ice maker clogging and
corrosion, as well as to help extend the life of your equipment. Each fi lter gives you up to six months of
better tasting water. After six months, just replace the fi lter. So start enjoying tastier beverages today.

IMPORTANT INSTALLATION INSTRUCTIONS

For use on 1/4" copper or plastic tubing.
1. Turn off your refrigerator's water source.
2. Locate an easily accessible section of tubing. Shut-off valve
(not included) must be on inlet side of filter. (Figure 1)
3. Cut and remove a 6" (15.24 cm) section of tubing making sure
ends are cut square. (Figure 2)
4. Apply one or two turns of PTFE tape to thread of push-in fitting.
Thread fittings into port of filter body. Tighten fittings snugly,
but do not overtighten. (Figure 3)
5. Connect the inlet port of the filter to incoming water line as
shown in quick connect guide. (Figure 4)
CAUTION
To reduce the risk associated with property damage due to
water leakage:
• Ensure all tubing and fi ttings are secure and free of leaks;
• Do not install unit if collet is missing. Contact CUNO if collets
are missing from any fi ttings.
To attach tubing:
O-Ring
Collet
1) Push tubing in as far as it will go. Tubing must
be inserted past o-ring and hit backstop.
2) Pull tube to ensure it is secured.
6. Turn on the incoming water supply to flush out
the filter into a bucket or pan for five minutes,
thereby removing fine particles of carbon
which may be present in the filter body. When
water is clear, stop the flushing procedure.
(Figure 5)
7. Connect the outlet port of the filter to the water
line going to your equipment being served.
(Figure 6)
8. Turn on water supply line. If leak occurs, tight-
en fittings or reinsert tubing until leak stops.

GETTING STARTED

3) Push in collet to release tubing.
4) With Collet held, pull tubing straight out.
Figure 4
Figure 5
Flow
Filter Inlet
Figure 1
Figure 2
Figure 3
To release tubing:
Figure 6

Publicidad

Tabla de contenido
loading

Tabla de contenido