Black and Decker BDH1800SM Manual De Instrucciones página 5

NOTICe:
Each steam cleaner is 100% tested in the factory to ensure product
performance and safety. When assembling your new steam cleaner for the first time you
may notice water residue inside of the unit.
WARNINg:
appliance is switched off and unplugged and that the appliance is cold and contains
minimal or no water.
STeAM CLeANeR ATTAChMeNTS
ATTAChINg The hOSe
NOZZLe - fig. B
• Press in the clips (6) on either side of the hose (5) or
variable nozzle (12).
• Align the two keys on the inside flange of the hose
or variable nozzle with the two slots adjacent to the
steam nozzle on the hand-held steam cleaner or
hose.
• Firmly press the hose or variable nozzle onto the
steam nozzle (7) of the hand-held steam cleaner or
hose such that it is fully seated, and release the clips.
WARNINg:
nozzle of the hose and handheald steam cleaner
before each use (figure C). If the seal is missing or
damaged contact your nearest authorized repair
agent. Do not use the appliance.
CAUTION:
nozzle is securely fastened before using the hand-held
steam cleaner.
ReMOvINg The hOSe
• Press in the clips on either side of the hose and pull
away from the steam nozzle.
ATTAChINg OTheR ACCeSSORIeS
TO The hOSe
• For accessories other than the variable nozzle, align the
lugs (8) on the hose with the recesses on the accessory.
• Press the accessory onto the hose and twist clockwise
until the accessory is fully seated and clicks into place.
ReMOvINg OTheR ACCeSSORIeS
fROM The hOSe
• For accessories other than the variable nozzle, twist
accessory counterclockwise then pull away from the hose.
fILLINg The WATeR TANk - fig. e
This steam cleaner incorporates an anti-calcium
system to help prolong the life of the system.
NOTICe:
Fill the water tank (11) with regular tap
water.
NOTICe:
In areas of very hard water, the use of
de-ionized water is recommended.
WARNINg:
supplied jug (10) to fill tank, and do not fill jug above
indicated max line.
• Ensure that the appliance is switched off and the
power cord is disconnected from the power supply.
• Place the steam cleaner in the upright position.
• Open the filler cap (9) by pulling down.
Before attempting any of the following operations, make sure that the
OR vARIABLe
Inspect the seal on the steam
Ensure that the hose and/or variable
- fig. D
Do not over fill the tank. Use
ASSeMBLy
5
B
6
12
7
6
5
C
Seal
D
e
10
9
11
8