Refitting Fascia & Access Panels - Dyson airblade Manual Del Propietário

ENG
Installation Procedures
Connecting to the
Electrical Supply
Step 3.
9
Terminal block connections:
120 volt unit:
Secure the Line, Neutral and
Ground wires into the proper
terminal block locations.
120v MODEL
Fig 9
Dyson Airblade
Hanging unit
.
cont
Hang the unit on the secured
mounting bracket as illustrated
in Fig 10 .
Secure the unit through the 4 holes
in the lower section of the unit,
illustrated in Fig 11 .
Fig 10
L N
TM hand dryer
Refitting Fascia &
Access Panels
Attach the front fascia panel back Install the (2) tamper proof screws
on by latching the top lip onto back into the inner section of the
the middle fascia first and then fascia panel.
pivoting the fascia cover
Re-install the Access panel and
downward until flush.
tamper proof screw.
Install the bottom left and right
Recommended minimum anchor
tamper proof screws back into the
size of 0.25"
machine using the supplied tool.
Fig 11