Connecting To Electrical Supply - Dyson airblade Manual Del Propietário

Installation Procedures
Connecting to the
Electrical Supply
CAUTION: Risk of electric Connect to the electrical supply
shock! Do not remove using approved flexible or solid
casing or attempt repair conduit and electrical fittings.
unless unit is being
Ensure that the flexible or solid
serviced by qualified
conduit and the electrical cable
service personnel.
is of sufficient length to make
If casing is removed or
the necessary connection to
handled improperly the
the backplate and that sufficient
internal components of
length to reach the terminal block.
the Dyson Airblade may
TM
cause harm or become
permanently damaged.
Fig 7
View from Back
2
Step 1.
Using a flat-head screwdriver, pry
the appropriate metal knock-out
from backplate in one of the
locations pictured in
Step 2.
Install electrical entrance fitting
into knock-out.
If mounting in knock-out 1:
Lay the unit flat on its back.
Fig 8
knock‑outs
Knock-outs
1
Remove the T-25 Torx screw at the
bottom of the PCB housing, tilt the
PCB housing up and pull
downward as illustrated in
Fig 7 . Pull outward of gasket and turn the
PCB Housing clockwise and set off
to the side. Route the incoming
supply wires to the terminal block
and secure them into the proper
locations as illustrated in Fig 9
Reconnect the PCB Housing in the
opposite order as it was removed.
Proceed to step 3.
Fig 8 .
If mounting in knock-out 2:
Route the incoming supply wires
to the terminal block and secure
them into the proper locations
as illustrated in Fig 9 .
.
Dyson Airblade TM hand dryer
ENG
8