Operation Checklist - GE P2S975 Instrucciones De Instalación

INSTALL THE RANGE
ALTERNATE CONSTRUCTION
25
PREPARATION (cont.)
ISLAND INSTALLATION
C
Attach the Anti-Tip bracket per instructions
in Step 19, making sure that the rear of the
bracket is 25" from the front of the
countertop.
Be aware that the screws provided are long
and may penetrate through the back of the
island cabinets. In this event, use shorter
screws (not provided) or the screws provided
should be used in the floor (see Step 19B for
Wood/Concrete Floor Installation).
Do not use Backguard Kit JXS32XX or
JXS37XX.
CABINETS OVER THE RANGE LESS
D
THAN 30"
If a 30" clearance between cooking surface
and overhead combustible material or metal
cabinets cannot be maintained, protect the
underside of the cabinets above the cooktop
with not less than 1/4" insulating millboard
covered with sheet metal not less than
0.0122" thick.
Installation Instructions
(CONT.)
18

OPERATION CHECKLIST

26
• Double check to make sure everything in
this guide has been completed. Rechecking
steps will ensure safe use of the cooktop.
• Make sure all controls are left in the OFF
position.
• Make sure the flow of combustion
and ventilation air to the cooktop is
unobstructed.
• The serial plate for your Range is located
under the oven door above the storage
area. In addition to the model and serial
numbers, it tells you the ratings of the
burners and the type of fuel and pressure
the cooktop was adjusted for when it left
the factory.
• When ordering parts, always include the
serial number and model number to ensure
proper replacement parts.
• Recheck Steps: Double check to make
sure everything in this guide has been
completed. Rechecking steps will ensure
safe use of the Range.
Please see L.P. conversion instructions
supplied with this range when L.P. Gas
is used.
NOTE: Instructions are mounted on
regulator bracket.