Maintenance And Cleaning - SATA 97925 Manual Del Uso

1 ） Push the switch to I/II according to the required temperature and air volume, and the hot air gun will start to beep. Then increase
or decrease outlet temperature and air flow gradually by pressing the button ④ . The LCD will display temperature in digital mode
and airflow in step mode The temperature increases or decreases by 10℃ each time.
8.3 Removal of Paint:
1 ） Install the correct fittings.
2 ） Set a high air temperature.
3 ） Start the hot air gun.
4 ） Direct the hot air gun at the paint to be removed.
5 ） When the paint is softened, scrape the paint off with a scraper.
Warning:
Do not remove the membrane paper of windows with metal frames by the hot air gun since the high temperature will be
transferred to the glass, which may make the glass burst. A scraper can be used to remove the membrane paper of windows
with frames of other materials
Warning:
Do not spray hot air at a point for too long time with the hot air gun to prevent surface combustion
Warning:
Avoid accumulating the paint on scraper fittings as it may be ignited. Carefully remove the paint from the scraper fittings with
a knife if necessary
8.4 Stationary use:
This tool can also be used in stationary patterns:
1 ） Place the tool on the workbench.
2 ） Fix the power wires in case the tool is detached from the workbench.
3 ） Be careful when starting the tool.
Warning:
Make sure the nozzle is always pointed away from the user and any spectator
Do not drop anything into the nozzle
8.5 Cooling:
During the use, the temperature of nozzles and fittings becomes very high. Cool these parts before moving or storing the tool:
1 ） To reduce cooling time, push the switch to I, adjust the hot air gun to the lowest temperature and highest air flow, and run it for a
few minutes.
2） Close the tool and cool it for at least 30 minutes.

9. Maintenance and Cleaning:

Warning:
Close the tool and disconnect the power supply before any maintenance
97925
中文
EN DE RU KO PT JA ES
17