DeWalt DCG412 Manual De Instrucciones página 67

4. Close the guard latch to secure the guard on the gear case. You
should not be able to rotate the guard by hand when the latch is
closed. Do not operate the grinder with a loose guard or the clamp
lever in open position.
5. To remove the guard, open the guard
latch, rotate the guard so that the arrows
are aligned and pull up on the guard.
NOTE: The guard is pre-adjusted to the
diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw (N) with clamp lever in the closed
position with guard installed on the tool.
CAUTION: Do not tighten the adjusting
screw with the clamp lever in the open position. Undetectable damage
to the guard or the mounting hub may result.
CAUTION: If the guard cannot be tightened by the adjusting clamp,
do not use the tool. To reduce the risk of personal injury, take the tool and
guard to a service center to repair or replace the guard.
NOTE: Edge grinding and cutting can be performed with Type
27 wheels designed and specified for this purpose; 1/4"
(6.35 mm) thick wheels are designed for surface grinding while thinner
Type 27 wheels need to be examined for the manufacturer's label to see
if they can be used for surface grinding or only edge grinding/cutting.
A Type 1 guard must be used for any wheel where surface grinding is
forbidden. Cutting can also be performed by using a Type 1 wheel and
a Type 1 guard.
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of serious personal injury, turn tool
off and remove the battery pack before making any adjustments
or removing/installing attachments or accessories. An accidental
start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 6)
NOTE: For best results, make sure your battery pack is fully charged.
FIG. 5
N
To install the battery pack (J) into the tool handle, align the battery pack
with the rails inside the tool's handle and slide it into the handle until
the battery pack is firmly seated in the tool and ensure that it does not
disengage.
To remove the battery pack from the tool, press the release button (O)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
FUEL GAUGE BATTERY PACKS (FIG. 7)
Some D
three green LED lights that indicate the level of charge remaining in the
battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
65
FIG. 6
J
WALT battery packs include a fuel gauge which consists of
e
75–100% charged
51–74% charged
O