Protecting The Environment - DeWalt DCG412 Manual De Instrucciones

2. Apply minimum pressure to work surface, allowing tool to operate at
high speed. Cutting rate is greatest when the tool operates at high
speed.
3. Once a cut is begun and a notch is established in the workpiece, do
not change the angle of the cut. Changing the angle will cause the
wheel to bend and may cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow the
tool to stop rotating before setting it down.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool
off and remove the battery pack before making any adjustments
or removing/installing attachments or accessories. An accidental
start-up can cause injury.
Your D WALT power tool has been designed to operate over a long
e
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing with dry air as
often as dirt is seen collecting in and around the air vents. Wear
approved eye protection and approved dust mask when performing this
procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
materials used in these parts. Use a cloth dampened only with water and
mild soap. Never let any liquid get inside the tool; never immerse any part
of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by D
have not been tested with this product, use of such accessories with this
tool could be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra
cost from your local dealer or authorized service center.
Repairs
The charger and battery pack are not serviceable.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.

Protecting the Environment

Separate collection. Products and batteries marked with this
symbol must not be disposed of with normal household waste.
Products and batteries contain materials that can be recovered or
recycled reducing the demand for raw materials. Please recycle electrical
products and batteries according to local provisions.
DCG412
* Maximum initial battery voltage (measured without a workload) is
20 volts. Nominal voltage is 18V.
WALT,
e
72
SPECIFICATIONS
20V Máx* 8 000 rpm
WALT,
e