Uline H-2536 Manual De Instrucciones página 3

ASSEMBLING THE TELESCOPIC WANDS
1. Locate both wand pieces and arrange them as
shown. (See Figure 4)
Figure 4
2. Remove retaining ring from top section and slide it
over the bottom section. (See Figure 5)
Figure 5
Ring Used To Be Here
3. Line up the ends and locate plastic tab inside the
hose end. This will align with the groove in the tool
end of wand. There is a bump you will need to
overcome. (See Figure 6)
Figure 6
Tab Is On The Inside Edge
Groove Should Be Visible Along Here
NOTE: It may be difficult to fit the sections
together.
4. Slide the retaining ring into place and tighten.
Loosen this collar to adjust the length and re-tighten
to lock into place. (See Figure 7)
PAGE 3 OF 18
ASSEMBLY INSTRUCTIONS
Hose End
Tool End
Ring is Now on Bottom Section
(Tool End)
Figure 7
5. Loosen collar and insert into tool head. Re-tighten
collar to lock into place. (See Figure 8)
NOTE: The tool is designed to swivel.
Figure 8
NOTE: Sometimes the locking ring on the inside
of the tool-end collar will pop out of place and
into one of the threads, preventing the collar
from closing all of the way. If this happens,
the tools will fall out and the collar won't
tighten all of the way. Push the ring down to
remedy. When properly placed and the collar
is tightened, the two ends of the rings should
touch each other. (See Figure 9)
Figure 9
Retaining Ring
Ring Is
Correctly
Placed
Ring Is
Popped Up
(Amount
May Vary)
0421 IH-2536