SATA 03055 Manual Del Uso página 48

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 191
03055 /03075
5. Read the value indicated on the screen after it is stable.
Note
For measurement of electrolytic capacitor, the black probe shall be connected to the negative pole of the capacitor, and the red probe to
the positive pole.
Note
1. When the probe has not been connected to the capacitor to be measured, the reading may be small rather than zero. In that case, press
"SELECT" button for resetting.
2. Before measurement, check that the capacitor to be measured has been fully discharged.
3. When the measured capacitance is greater than 10 μF, it may take about 30 s to obtain a stable reading.
- Frequency measurement (only for 03057 model)
1. Connect the black probe to "COM" jack and the red probe to "
2. Set the function switch to "Hz%" position.
3. Press and hold "SELECT" button until "Hz" symbol appears on the screen.
4. Connect the probes to the two ends of the power or circuit to be measured.
5. Take the readings.
- 03 -
48
" jack.
EN
DE
RU
KO
PT
JA
ES

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

03057

Tabla de contenido