Tabla de contenido
Publicidad
EN
|
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
In order to avoid a hazardous situation, this appliance must never
be connected to a timer switch.
Do not use the appliance if the mains cord, the plug or other
parts are damaged.
If the mains cord is damaged, it must be replaced by Philips, a
service centre authorised by Philips or similarly qualified persons
in order to avoid a hazard.
Keep the appliance out of the reach of children.
Never let the appliance run unattended.
Always switch the appliance off by turning the control knob to 0.
Switch the appliance off before detaching any accessory.
Unplug the appliance immediately after use.
Never immerse the motor unit in water or any other liquid, nor
rinse it under the tap.
Never use your fingers or an object (e.g. a spatula) to push
ingredients down the feed tube while the appliance is running.
Only the pusher is to be used for this purpose.
Be very careful when handling the blades or inserts, especially
when removing them from the bowl or jar, when emptying the
bowl or jar and during cleaning.Their cutting edges are very sharp!
Always unplug the appliance before reaching into the blender jar
with your fingers or an object (e.g. a spatula).
Wait until moving parts have stopped running before you remove
the lid of the bowl or jar.
Never use any accessories or parts from other manufacturers or
that have not been specifically advised by Philips.Your guarantee
will become invalid if such accessories or parts have been used.
Do not exceed the maximum content indicated on the bowl or
the blender jar.
Consult the table in these directions for use for the correct
processing times.
4
Cucina
Let hot ingredients cool down before processing them (max.
temperature 80cC/175cF).
The food-processing functions and the citrus press can only be
used when the blender cap is attached.
Note that it is not possible to use the food-processing functions
when the blender is attached to the motor unit!
Do not use the juicer if the rotating sieve is damaged.
Thoroughly clean the parts that will come into contact with food
before you use the appliance for the first time.
Thermal safety cut-out
This appliance is equipped with a thermal safety cut-out which will
automatically cut off the power supply to the appliance in case of
overheating.
If your appliance stops running:
-
Pull the mains plug out of the socket.
-
Let the appliance cool down for 60 minutes.
-
Put the mains plug in the socket.
-
Switch the appliance on again.
Please contact your Philips dealer or an authorised Philips service
centre if the thermal safety cut-out is activated too often.
FR
|
Important
Lisez ces instructions avant d'utiliser l'appareil et conservez-les pour un
usage ultérieur.
Avant de brancher l'appareil, vérifiez que la tension indiquée sur
l'appareil correspond à la tension du secteur de votre logement.
Afin d'éviter tout accident causé par la remise en marche de
l'interrupteur de sécurité thermique, l'appareil ne doit pas être
connecté à un minuteur.
N'utilisez pas l'appareil si le cordon d'alimentation, la fiche ou
d'autres pièces sont détériorées.
Si le cordon d'alimentation est endommagé, il ne doit être
remplacé que par Philips ou par un Centre Service Agréé, pour
éviter tout accident.
Publicidad
Tabla de contenido
