Velleman-Kit K8057 Manual Del Usuario página 7

Receiver instructions
At power up, the 'CONFIRM'-led (LD4) turns on, hereby indicating that the unit is operational. At this time, it will respond to
the default code emitted by the transmitter. If you have changed the code of your transmitter (recommended), then the
receiver needs to 'learn' the new code.
To learn a remote :
1. Hold 'setup' button, 'SELECT'-led (LD3) turns on after a few seconds.
2. Hold any remote button.
3. 'CONFIRM'-led (LD4) lights when the code has been grabbed.
4. Release 'setup' button.
Repeat steps 1 through 4 so the receiver can learn the codes for other transmitters

31 transmitters can be stored.

If the memory is full, 'SELECT' (LD3) and 'CONFIRM' (LD3) will flash simultaneously when 'setup' button is pressed
To remove all remotes from memory :
1. Turn off the power (remove power cord).
2. Hold 'setup' button
3. Turn on power
DISCONNECT RELAY OUTPUTS DURING SETUP!
Receiver instructions
7