Manipulating Of Battery Protector(Low Voltage Protection) - Klarstein 10031337 Manual Del Usuario

Manipulating of battery protector(Low voltage protection)

• While the battery's voltage drops to the setup data,freezer' s compressor will stop working. so as to protect
the battery against over discharge;Once the battery' s voltage reaches the restart data after charging,
freezer' s compressor will start immediately.
• While the battery's voltage is too low, battery protector will take effect.Red malfuntion indicator light will
blink. Now you need to charge the battery.
• While the battery protector cut off the battery connection,you should warrant the battery to be charged
sufficiently, so as avoid frequent restarting of compressor.
• Counterpart volatage form for Gear of battery protector.
Counterpart volatage form for Gear of battery protector
Power supply
DC 12 V
DC 24 V
• If you use aoto power for starting the battery power, HI gear is proposed,so as to warrant that vehicle's
battery power is in high level.
• If you use additional battery for power supply, LO gear is applicable.
If you use AC/DC adapter(External Adatper)for power supply, please set the battery protector to LO
gear.
• Freezer is designed to have the function to rework when connect to power after p ower off. If the freezer
is shutdown under abnormal situation, it will work automatically when connect to power again.
Status of battery
Low mode (LO)
protector
Cutting-off Volt-
10,1 ±0,3 V
age
Restaring Voltage 11,1 ±0,3 V
Cutting-off Volt-
21,5 ±0,3 V
age
Restaring Voltage 23,0 ±0,3 V
Middle mode (MED) High (HI)
11,4 ±0,3 V 11,8 ±0,3 V
12,2 ±0,3 V 12,6 ±0,3 V
24,1 ±0,3 V 24,6 ±0,3 V
25,3 ±0,3 V 26,2 ±0,3 V
20