Technical Specifications - Flex ALC 3/1-G Instrucciones De Funcionamiento

FLEX ALC 3/1-G

Technical specifications

Cross-line laser ALC 3/1-G
Visible laser diode
Laser class
Work area
– Horizontal/vertical beam
– Ground beam (plumb)
Precision ...
– Horizontal/vertical beam
– Ground beam (plumb)
Self-levelling range
Lithium polymer battery
2)
Operating duration
Temperature range
– for operation
– for storage
Weight
USB charger
Input voltage
Output voltage
1) The measurement range may be less under
unfavourable conditions (bright sunlight,
reflective surfaces).
14
520–650 nm
2
1)
20 m
5 m
± 0.3 mm/m
± 0.6 mm/m
± 4°
2000 mAh / 3,7 V
6 h
–5 °C ... 50 °C
–20 °C ... 70 °C
520 g
100-240 V~
5V / 1A
2) The operating duration was determined with
all activated laser beams.
The operating duration can be extended
if beams which are not required are switched
off by selecting a different operating mode.
Instructions for use
WARNING!
– Do not point the laser beam at people
or animals.
– Do not look into the laser beam.
– Do not put any optical instruments in the
path of the beam.
This measuring instrument generates laser
radiation which may cause blindness.
CAUTION!
– Do not use the measuring instrument
in a damp, dusty or sandy environment.
Device components may be damaged.
– After using the device, immediately switch it
off with the On/Off switch in order to block
self-levelling.
– If the device is brought from a very cold
to a warmer environment or vice versa,
you should allow the device to acclimatise
before using it.