Checking Precision; Maintenance And Care; Disposal Information - Flex ALC 3/1-G Instrucciones De Funcionamiento

– If using adapters and tripods, ensure that
the device is screwed on tightly.
The most important operating steps are
explained at the end of these instructions
on the illustrated pages.
See from page 152.
Battery charging with USB cable and
USB charger ........................................... 152
Switching the device on and off ............. 154
Selecting the operating mode ................ 156
Switching over ambient mode ................ 158
Handling the laser .................................. 160
Testing the horizontal beam ................... 162
Testing the vertical beam ....................... 166

Checking precision

It is recommended to check the device
regularly to ensure that it is always precise.
If the precision deviates from the permitted
tolerance range, the device must be taken
to a customer service workshop authorised
by the manufacturer.
Have the device adjusted by authorised
technicians only.
The steps required to check the precision
are explained at the end of these instructions
on the illustrated pages. See from page 162.

Maintenance and care

Observe the following instructions:
– Handle the device with care and protect
it from impacts, vibrations, extreme
temperatures.
– When the device is not in use, keep
it in the protective pouch.
– Clean the lens with a soft, dry cloth only.
– Have the device repaired by qualified
technicians and with original spare parts
only. This ensures that the safety of the
device is maintained.

Disposal information

EU countries only:
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
FLEX ALC 3/1-G
15