Troubleshooting; Maintenance; Important - Atec Venice Instrucciones De Montaje

Pag. 12 di 36
4.2 MONITOR ENCODING WITH 3-BUTTON CAMERA
A three-button Venice camera can be connected to at
most two additional panels, which must be encoded as
shown in the table.
Each camera and additional panel button can be
encoded for one or more monitors.
WARNING: Each button must be set to a different
monitor code.
The table shows the monitor dip switch settings.
Each monitor must correspond to a camera or additional
panel button.
The wiring diagram shows the
connection scheme for a three-button
Venice camera.
NOTE: dip switch 10 on monitor 3
must be set to ON.
The wiring diagram shows the
connection scheme of a single-button
Venice camera and two additional
panels.
NOTE: dip switch 10 must be set to
ON on both monitors 6 and 13.
5. COME RISOLVERE I PROBLEMI
Problem
The set doesn' t operate
Image is not clear enough
Interphone does not work

6. MAINTENANCE

Periodically clean the set with a dry cluster.
Don't use chemical products like benzene to execute the cleaning
Solution
- The power supply cable is not
properly inserted in the AC outlet, or
the AC is not supplied.
- Wires between MONITOR and
CAMERA are shorted, disconnected
or misplaced in polarity connections.
- Set's wires must stay in distance
from other cables.
- Are the MONITOR screen and
CAMERA lens clean?
- Is the handset cord
disconnected from the monitor?
For 3-button camera

!! IMPORTANT !!

SAVE THESE INSTRUCTIONS
1° - Keep your videophone away from strong
magnetic force such as TV or video (It
has risk of affecting screen image badly).
2° - Set's wires must stay in distance from
other cables.
3° - Do not spill water directly onto the
videophone (It causes trouble to the
videophone).
4° - Keep the videophone from any physical
shock (It causes disorder or damage).
5° - Don't install the videophone in direct sun
light or strong reflected rays.
6° - Plug out the adaptor from the wall outlet
in case of no use for a long time.
7° - Don't connect many lines to one plug as
shown on this drawing (It may cause fire
or disorder).
8° - Don't install the videophone near the
ammonia, acid materials and poisonous
gas (It causes disorder).
9° - High voltage flows inside the system.
Don't disassemble the unit carelessly (It
causes disorder or electric shock).
ATEL ACCEPTS IS NOT LIABLE for any
damage caused by the not abiding of the
safety regulations and laws at present in force
not being observed during installation.
- Declare under our
responsibility that the
product is conform to the
following standards:
EN50081-1 1997
EN50082-1 1992
EN60065 1994
EN 55022 1995
EN 61000-4-5 1995
EN 61000-4-11 1994
EN 61000-4-2 1995
EN 61000-4-4 1995
EN 61000-3-2 1993
EN 61000-3-3 1994
EN61000-4-3 1996
EN61000-4-6 1997
As requested by the following
Directives
EC 89/336
EC 92/31
EC 93/68
EC 73/23