Product Safety Information; Product Specifications; Torque Adjustment - Ingersoll Rand 180PQ1-EU Especificaciones Del Producto

Product Safety Information

Intended Use:
These tools are designed to remove and install threaded fasteners.
For additional information refer to Air Pulse Tool Product Safety Information Manual
Form 04584983.
Manuals can be downloaded from www.ingersollrandproducts.com

Product Specifications

Model(s) Style
180PQ1-EU Pistol
280PQ1-EU Pistol
280P-EU Pistol
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16585747 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
After each 20,000 cycles, or as experience indicates, drain and refill the Impulse Unit Drive
Assembly using the Fluid Replacement Kit (Part No. EQ106S-K400). Lubricate the hex drive and
the output shaft before assembly.

Torque Adjustment

See drawing 47132956 on Page 2.
To adjust the torque on these Twin Blade Impulse Wrenches, proceed as follows:
1. Remove the Socket Plug.
2. Rotate the Drive Shaft until the Torque Adjustment Screw is visible in the opening.
3. Using a 1.5 mm hex wrench, rotate the Torque Adjustment Screw clockwise to increase
torque. To decrease torque, rotate the Torque Adjustment Screw counterclockwise.
4. Replace the Socket Plug.
80167562_ed2
Drive
Type Size
Insert Bit 1/4"
Insert Bit 3/8"
Insert Bit 3/8"
Free Sound Level dB (A)
Speed (ANSI S5.1-1971)
rpm Pressure
10500 78.8
9500 76.5
9500 76.5
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
EN
Vibration Level
(ISO28927)
m/s²
< 2.5
< 2.5
< 2.5
EN-1