Unpacking - Delta 50-905 Manual De Instrucciones

®
Your DELTA 1 ½ HP Portable Cyclone Dust Collector comes packed in a single container. Before attempting to
assemble this machine, follow these directions for unpacking:
• Carefully cut the banding straps and remove them from the container.
• Cut along the tape line at the top of the container.
• Remove all parts from the top of the packing foam and set aside.
• Remove foam packing material from the top of the machine.
• Carefully cut each of the four corners from top to bottom and fold down all four sides of the container to fully
expose the machine and component parts.
• Using the diagram in Fig. 1 and Fig. 2, ensure that all parts are present and in good condition.
dESCRIPTION (qUANTITY) FIgURE 1
A. Drum Lift Bar (1)
B. Drum Cover (1)
C. Drum Bags (3)
D. Extra Filter Bags (3)
E Bag Suction Hose (1)
F. Inlet Splitter (1)
G. Accessory Box (1)
H. Owner's Manual (1)
I. Drum (1)
J. Portable Cyclone Dust Collector (1)
CONTENTS OF ACCESSORY BOx-FIgURE 2
A. Remote Control (1)
B. 3" Drum Casters (4)
C. 4" Swivel Casters (4)
D. Hardware Bag (1)
E. Filter Cleaning Crank (1)
F. 3 x 6 x 0.8mm Foam Tape (1)
Report any missing or damaged parts to your dealer or distributor. Prior to tool assembly and use, read this
manual thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.

UNPACKINg

FIg 1
G. 1 ¼" Hose Clamps (2)
H. Drum Lift Pins (2)
I. Drum Gasket (2M R-Type PVC Tape) (1)
J. 4" Dust Port Covers (2)
CONTENTS OF hARdwARE BAg (d)
5/16" x ¾" Hex Head Screws (Electro-coated) (17)
5/16" x ¾" Phillips Head Screws (Electro-coated) (18)
M8 x 30mm Hex Head Screws (2)
M4 x 12mm Pan Head Screws (Electro-coated) (3)
3/8" x 21mm x 12mm Hex Head Screws (2)
5/16" x 18mm x 2t Flat Washers (Electro-coated) (16)
5/16" x 23mm x 2t Flat washer (1)
3/8" x 23mm x 2t Flat Washer (Electro-coated) (4)
5/16" Lock Washers (Electro-coated) (18)
3/8" Lock Washers (Electro-coated) (4)
3/8" Hex Fastener Nuts (Electro-coated) (2)
5/16" Hex Nuts (Electro-coated) (18)
3/8" Hex Nut (Electro-coated) (4)
8
FIg 2