How To Assemble Your Ceiling Fan - Fanimation Enigma FP2120 Serie Manual Del Propietário

Electrical and Structural Requirements (Continued)
No blocking (Figure 3)
Paired with a deep box, this hanger is meant to span
between two joists and takes the place of wooden
WARNING
To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked acceptable for fan
support of 22.7 kg (50 lbs) or less and use mounting
screws provided with the outlet box and/or support
directly from building structure. Most outlet boxes
commonly used for the support of luminaires are not
acceptable for fan support and may need to be
replaced, consult a qualified electrician if in doubt.
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and
remove the existing light fixture.
WARNING
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
1. To prevent damage to housing and/or blade, leave
the Ceiling Fan Assembly in its original packing during
installation of lower cover assembly, down rod, ceiling
canopy and motor coupling cover.
NOTE: Do not set Ceiling Fan Assembly on oor or hard
surface.
2. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
3. Assemble the Lower Cover Assembly by connecting
the 2-pin (black & white wires) socket connector to
the plug connector (blue & white wires). Be sure the
connector wires are inside the Control Housing before
assembling the Lower Cover Assembly. (Figure 1)
4. Locate and loosen two Indexing Screws located on the
Control Housing. (Figure 1) Line up the indexing holes
over the screws, secure by twisting the Lower Cover
Assembly clockwise and tighten the two indexing screws.
(Figure 2)
5. Turn the Ceiling Fan Assembly (in package) top-side
up for installing down rod, ceiling canopy and motor
coupling cover.

How to Assemble Your Ceiling Fan

CEILING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
2-pin
connector
5
CEILING JOIST
Figure 3
WARNING
Indexing
Holes
(2 places)
Figure 1
Figure 2
OUTLET BOX
Index Screw
(2 places)
Control
Housing