Changing The Remote Control Battery; Product Registration - Klipsch iGroove HG Manual Del Usuario

CHANGING THE REMOTE CONTROL BATTERY

The remote battery will need to be changed
when it stops working or when its performance is
noticeably reduced. To remove the battery, simply
pull the battery housing tab from the remote
control (as shown in the diagram) and remove the
battery. Replace only with a 3-volt CR2025 lithium
battery.
Note: Lighting and other room conditions can
reduce remote performance.
THE SHUFFLE AND OTHER NON-DOCKING
MP3 PLAYERS
The iGroove comes with a convenient solution
for allowing the use of the iPod Shuffle and other
MP3 players. The "J-Cup" insert can be placed
in the docking area for MP3 players that use a
standard mini-jack (headphone) stereo output.
Simply insert the "J-Cup" into the docking location
while making sure to line up the stereo mini-plug
on the bottom of the "J-Cup" with the input socket
in the bottom of the dock area. With the "J-Cup" in
place, the stereo mini-plug on top of the "J-Cup"
can be inserted into most MP3 players.
Note: When using the "J-Cup" system, the remote
control will no longer have tracking and play/
pause capabilities.
Note: The moveable back rest must be in its top
most position for the "J-Cup" to insert properly.

PRODUCT REGISTRATION

Register your product online at
www.klipsch.com/register
• Keep up-to-date on new products and
promotions
• Your personal information will never be resold
• This registration information is not used for
warranty purposes.
Please retain your receipt for warranty claims.
FCC AND CANADA EMC COMPLIANCE
INFORMATION
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential instal-
lation. This equipment generates, uses and can
radiate radio frequency energy and, if not in-stalled
and used in accordance with the instructions, may
cause harmful interference to radio communica-
tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Approved under the verification provision of FCC
Part 15 as a Class B Digital Device.
Caution: Changes or modifications not expressly
approved by the manufacturer could void the user's
authority to operate this device.
This Class B digital apparatus complies with Cana-