Placing Tool In Service - Ingersoll Rand 103 Manual De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- - Rand No. 10
Always use an air line lubricator with this tool.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International - - No. C28- - C4- - FKG0
For USA - - No. C28- - 04- - FKG0- - 28
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 10 Oil
into (3).
After each 40 hours of operation, lubricate the Gearing.
Remove (25) by rotating it counter- - clockwise to remove
(26) and to expose the gearing. Coat (23) with a thin film
of Ingersoll- - Rand No. 28 Grease.
Periodically, inject several drops of Ingersoll- - Rand
No. 10 Oil between (26) and (31) to lubricate the (30).
Model Free Speed,
rpm
103, 103- - EU 200
Tested in accordance with ANSI S5.1- - 1971 at free speed
H
♦ Tested to ISO8662- - 1 loaded with frictionbrake to 9 RPM
ISO3744
•
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620kPa)

PLACING TOOL IN SERVICE

Ingersoll- - Rand No. 28
Ingersoll- - Rand No. 66
SPECIFICATIONS
Drive Recommended
Torque Range
in
1/4" 5 to 20
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
To help promote durability and performance of the
Ratchet Head, periodically disassemble, degrease and
re- - lubricate the internal parts of the Ratchet Head
with Ingersoll- - Rand No. 66 Grease. If the Ratchet
Head "hangs up," it is usually due to lack of
lubrication.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
mm Pressure
7 to 27
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905- -1)
HSound Level
dB (A) tions Level
•Power
87.7 100.7
WARNING
♦Vibra-
2
m/s
4.6