Placing Tool In Service - Ingersoll Rand BP10P3–EU Manual De Instrucciones

•
When not in use, lock the Trigger Switch by putting
the Forward/Reverse Lever in the neutral (center)
position.
•
Store idle tools. When not in use, tools should be
stored in a dry, high or secured place.
•
This tool is always in an operating condition. It
does not have to be plugged into an electrical outlet in
order to operate.
•
Accessories. The use of accessories or attachments
other than those recommended might present a
hazard.
•
Be sure the Battery is securely latched in position
when inserted into the tool.
•
An extension cord should not be used unless
absolutely necessary. Use of an improper extension
cord could cause fire or electric shock. If an
extension cord must be used, be sure it meets the
following requirements:
a. The pins on the plug of the extension cord must
be the same number, size and shape as those on
the plug of the Battery Charger.
b. The extension cord must be properly wired and in
good electrical condition.
c. The wire size must be large enough for the AC
ampere rating of the Battery Charger as specified:
TORQUE ADJUSTMENT
1. Remove the Battery from the tool.
2. Rotate the Drive Shaft until the Torque Adjustment
Screw is visible in the opening in the Housing Cover
below the Drive Shaft.
3. Using the 1.5 mm Hex Wrench, rotate the Adjustment
Screw clockwise to increase the torque output and
counterclockwise to decrease the torque output.
Do not rotate the Oil Plug .
Make all final adjustments at the job.
LUBRICATION
Ingersoll–Rand No. 67
TOOL AND CHARGER USE AND CARE

PLACING TOOL IN SERVICE

Ingersoll–Rand Fluid
Part No. EQ106S–400–1
AWG SIZE OF CORD FOR LENGTH OF CORD
Feet 25
American 18
Wire Gage
d. An extension cord is a temporary solution. Move
the Charger to a standard receptacle as soon as the
job has been completed.
•
Don't abuse the cord. Never carry Charger by cord or
yank it to disconnect from receptacle. Keep cord from
heat, oil and sharp edges.
•
Do not operate Battery Charger if it has received a
sharp blow, been dropped or otherwise damaged in
any way. If any of these conditions occur, take the
Battery Charger to a qualified serviceman for repair.
•
Do not disassemble the Battery Charger. Take it to a
qualified serviceman when service or repair is
required.
•
Inspect plug and cord before each use. Replace
them if they show wear or damage.
After each 20 000 cycles, or as experience indicates, drain
and refill the Impulse Unit Drive Assembly as instructed in
this manual using the Fluid Replacement Kit (Part No.
EQ106S–K400). Lubricate the hex drive, the output shaft
and the gearing with Ingersoll–Rand No. 67 Grease before
assembly.
Operating the Battery Charger
Models BP10P3–951–UL and BP10P3–952–UL are
certified by Underwriters Laboratory for use in the United
States.
Models BP10P3–951–CSA and BP10P3–952–CSA are
certified for use in Canada.
Model BP10P3–951–EU is certified for use in the
European Common Market
Read the following instructions before using any of the
Battery Chargers listed above.
3
50 100 150
18 18 16