Hog Slat AccuCrank Instrucciones De Montaje página 5

Nursery Feeder AccuCrank™
Assembling
The following steps are written for (2) people to assemble the feeder together, one person
working from each end of feeder.
Step #1
Place feeder bottom (A) upside down on top of workstation. Next take the ends (B) and attach
one on each end of bottom. Make sure when you attach the ends to the bottom that the pre
punched holes match up with the bottom panel.
Step #2
Use 1/4" x 1/2" bolts (Item1) and 1/4" locknuts (Item 5) to attach the ends to the bottom. Put all
the bolts and locknuts on the bottom of end panel. Use 1/4" x 3/4" bolts (Item 2), flat washer
(Item 3) (on the inside), and 1/4" locknuts to attach the ends to the front of the end panel.
Tighten all bolts.
Note: After you have completed step #2, check all bend corners on bottom making sure
there are no open gaps. If any corner gaps are present, use 100% Silicone Caulk
Industrial Grade RTV to seal off gaps.
Hog Slat Inc. Newton Grove, NC USA August 2016 5