Hog Slat AccuCrank Instrucciones De Montaje página 6

Nursery Feeder AccuCrank™
Step #3
Take feeder bottom and attached end panels that now have the bolts tightened and turn feeder
right side up and set on the floor. Attach the door tracks (C) one on each end panel using two
1/4" X 1/2" bolts (Item 1) and 1/4" locknuts (Item 5) to fasten to each end panel. The bolt head
on this assembly is to the inside of the feeder. There are three holes punched in each door
track. When the door track is assembled correctly, the one extra hole not used for a bolt will be
located towards the bottom of the feeder. Tighten all bolts on the door track attached to the
feeder end.
Step #4
Insert the door (D) into the door tracks. Make sure the smooth side of the door is to the inside of
the feeder. Also, there is a hole punched on each end of the door. When the door is inserted
properly into feeder the hole is closer to the bottom of the feeder.
Hog Slat Inc. Newton Grove, NC USA August 2016 6