Hog Slat AccuCrank Instrucciones De Montaje página 8

Nursery Feeder AccuCrank™
Step #6
Set feeder back on the floor and attach the adjustment assembly (F) with (Item 1) and (Item 5).
Install door adjustment rods (H) into door panel (D) using 3/8" lock nut (Item 9). (Tighten to
where only 1-2 threads are showing - see DETAIL C). Install adjustment rod (H) into the
adjustment indicator bracket (G) (with indicator and jam nuts (Item 8) loose) using the
adjustment screw to screw in the adjustment rod (DETAIL A). When you have the feeder door in
the down position adjust indicator to the #1 mark on the label position. Use jam nuts to lock it
into that position (DETAIL B).
Test the range of adjustment on the crank adjustment (F) to make sure door (D) has full range
capabilities.
DETAIL A
DETAIL B
DETAIL C
Hog Slat Inc. Newton Grove, NC USA August 2016 8