Stenner Pumps CLASSIC Serie Instrucciones De Instalación

CLASSIC SERIES PUMP COVER
Installation Instructions
NOTICE: Before installing or servicing the pump, read the pump manual for all safety information and complete instructions. The pump is
designed for installation and service by properly trained personnel.
Must be installed with the Stenner Rain Roof; part number MP90000.
To be used only with pumps that run intermittently. 25% duty cycle max (10 min. ON, 30 min. OFF). Maximum ambient
operating temperature is 104° F (40° C). Continuous operation, especially in direct sunlight, will cause the pump to shut down due to
thermal overload protection.
A
Power cord through
top vent
Slide the Pump Cover
over the pump
B
C
Power
cord
through
top vent
Button closed
Button secured
This information is not intended for specific application purposes. Stenner Pump Company reserves the right to make changes to prices, products, and specifications at any time without prior notice.
Stenner Pump Company
3174 DeSalvo Road
Jacksonville, Florida 32246 USA
Rain Roof
➊
Turn off unit and unplug the pump.
➋
Remove the rain roof (if already installed).
➌
Insert the power cord through the bottom of the cover and out through the top vent and
slide the pump cover over the pump as shown. Ensure that vent intake and exhaust are
unobstructed. Figure A
➍
Button cover to secure it. Figure B
➎
Install rain roof. Figure C
➏
Plug unit in and turn pump on.
Phone
US Toll Free
Fax
Classic Series Button
Single Head Pump
904.641.1666
800.683.2378
904.642.1012
Pump Cover
INSPC Rev0712
www.stenner.com
sales@stenner.com
© Stenner Pump Company All Rights Reserved