OHAUS CKW Serie Instrucciones De Instalación Y Operación página 9

EN-8
TABLE 1. SERIAL INTERFACE COMMAND TABLE.
Command
Character
PU
P
T
Z
xS
xP
xCM
xCU
xCO
xCT
xU
PV
xT
* Up to 6 numeric characters, an optional "-" sign, and single decimal point
(e.g., 1.000CU, 2:3.2CU) Use colon ":" as a separator for lb:oz data entry.
Note: All commands must be followed by a carriage return, <cr>, or carriage
return-line feed, <cr><lf>, sequence. For addressed RS485 communication, all
commands must be preceded by the "@" character and a two digit address.
Description
Print current weighing unit: kg, g, lb, oz, lb:oz, %.
Same as pressing PRINT button.
Same as pressing TARE button.
Same as pressing ZERO button.
Enable print stable data only. Where x=0 for Off, x=1 for On.
Auto print condition. Where x = 1 to 3600 second intervals,
x=0 for Off, x=C for Continuous, x=S for On Stable.
Checkweigh Input Mode, where x=0 for Range, 1=Variance,
2=Percent (%).
Set Under value, as a Range, Variance or Percent value
(depending on Checkweigh Input Mode setting).*
Set Over value, as a Range, Variance or Percent value
(depending on Checkweigh Input Mode setting).*
Set Target value (used only in Variance and Percent Input
Modes, not used in range Mode)*.
Set weighing unit: Where x=1 to 6, 1=g, 2=kg, 3=lb, 4=oz,
5=lb:oz, 6=%, if x=blank, then increment to next available
mode. (The unit can not be selected if it is not enabled).
Print model name, software revisions, and LFT status - if on, (eg.
"CKW-55 Sr1.28 RS485 Sr1.25"
Set a pre-set tare value of x, in present weighing units*
CKW Serial Interface Option Kit