Service; Blade Sharpening - Jacobsen RYAN JR. SODCUTTER Serie Manual De Servicio Y Piezas

SERVICE

When replacement parts are required, use
genuine RYAN parts or parts with equivalent
characteristics, including type, strength and
material. Failure to do so may result in product
malfunction and possible injury to the operator
and/or bystanders.
Carbon monoxide present in the exhaust is an
odorless and deadly gas. Never start or run the
engine inside where exhaust fumes can collect.
Provide enough fresh air to keep fumes from
getting too strong.
When replacing engine, be sure to replace
sound level warning decal (Part No. 524538).
Any warning decal that becomes illegible should
be replaced immediately.

BLADE SHARPENING

1. Hand file bottom blade at 45
remains.
2. To keep cutting edge less than 1/16" on 45
angle, grind milled surface back at 15
than 1/16".
3. Hand file side blades at 45
4. To keep cutting edge less than 1/16" on 45
angle, grind milled surface back at 15
than 1/16".
GB-8
O angle until no flat
O
O to less
O
until no flat remains.
O
O
to less
STOP engine and disconnect spark plug wire
before servicing or making adjustments to unit.
The preceding decal shows what could happen
if the engine is not stopped or disabled before
removing safety covers. Hands may become
entangled in moving belts, gears, chains or other
parts.
Use adequate lifting device (i.e., hoist, fork lift,
etc.) to raise unit.
Use adequate supports when unit is raised for
servicing.
Wear protective eye equipment when using
hammers, chisels and punches.
BOTTOM BLADE
O
45
1/16"
Maximum
SIDE BLADE
THIS SURFACE SMOOTH
1/16" MAX
FILE
DIRECTION
FILE
DIRECTION
Jr.
Sodcutter
840697
FILE
DIRECTION
O
15
THIS
SURFACE
SMOOTH
(No Burrs)
(No Burrs)
MILLED
EDGE