Rehaforum MEDICAL Actimo Manual Del Usuario página 8

To remove the mounts, operate the locking mechanism, swivel the mounts outwards and fold the foot
flaps up.
Now the mounts can be pulled off upwards.
5. Adjustment of the seat height: To ad-
just this, loosen the front wheels in the
forks and the axle screws of the rear
wheels. Set the front and rear wheels
to the desired height.
6. To loosen and fold up the armrests,
press the locking lever at the lower end
of the side frame.
To fix the armrests, fold them down un-
til the mount clicks into place (clearly
audible).
8. To remove the rear wheels (drive wheels), press the
button on the quick-release axle and grasp the spokes
with four fingers. Then pull the drive wheel out of the
[8]
7. When stationary, apply the parking brake (tyre
brake). Press the lever for this forwards until it holds
by itself. The wheelchair is now standing safely and
you can now turn or simply just park. The parking
brake is released by pulling the lever backwards.
axle
mounting.
To fit the
drive wheel, with the thumb press the button of the quick-
release axle again. Now insert the drive wheel (the quick-
release axle) in its mounting, the quick-release axle locks in-
to place automatically.
9. The tilting aids make it easier for the companion to tilt the
wheelchair and so comfortably
move over obstacles. First push the
anti-tilt wheels into the highest po-
sition. Place your foot on the lever
and keep your balance using the
push handles.